|
The Tupolev TB-3 ((ロシア語:Тяжёлый Бомбардировщик), Tyazholy Bombardirovschik, Heavy Bomber, civilian designation ANT-6) was a heavy bomber aircraft which was deployed by the Soviet Air Force in the 1930s and during World War II. It was the world's first cantilever wing four-engine heavy bomber. Despite obsolescence and being officially withdrawn from service in 1939, the TB-3 performed bomber and transport duties throughout much of World War II. The TB-3 also saw combat as a Zveno project fighter mothership and as a light tank transport. ==Development== In 1925, the Soviet Air Force approached TsAGI with a requirement for a heavy bomber with total engine output of 2,000 PS (1,970 hp) and either wheeled or float landing gear. Tupolev OKB started design work in 1926 with the government operational requirements finalized in 1929.〔〔Gunston 1995, pp. 384–385.〕 The Tupolev TB-1 was taken as the basis for the design and the aircraft was initially powered by Curtiss V-1570 "Conqueror" engines generating 600 PS (590 hp) each,〔Duffy and Kandalov 1996, p.42.〕 with the intent of switching to Mikulin M-17s (modified BMW VIs) in production.〔〔Vanags-Baginskis 1988, p.5.〕 The mock-up was approved on 21 March 1930 and the first prototype was completed on 31 October 1930.〔 The aircraft flew on 22 December 1930 with Mikhail Gromov at the controls and with ski landing gear. Despite almost crashing owing to vibration causing the throttles to close, the test flight was a success.〔〔 On 20 February 1931, the Soviet Air Force approved mass production of the ANT-6 with M-17 engines.〔Gunston 1995, p.385.〕 The prototype was refitted with BMW VIz 500 engines of 730 PS (720 hp) each, larger radiators, and wooden fixed-pitch propellers of TsAGI design. Single-wheel landing gear was deemed too weak and was replaced by tandem bogies with 1,350×300 mm (53×12 in) tires.〔 The first pre-production TB-3-4M-17 flew on 4 January 1932 with A. B. Yumashev and I. F. Petrov at the controls. Unexpectedly, subsequent mass-produced aircraft were found to be 10–12% heavier than the prototype, which significantly hampered performance.〔 The discrepancy was discovered to be due to high positive tolerances on raw materials which resulted in steel sheetmetal, pipes, and wires being much thicker than on the carefully constructed prototypes. The aircraft were also more crudely painted with a thick layer of camouflage and lacquer.〔〔Duffy and Kandalov 1996, p.43.〕 The factories asked the workers for suggestions on reducing the weight, paying 100 roubles for each kilogram (2.2 lb) removed from the aircraft. In combination with OKB efforts, this resulted in weight savings of almost . Despite this, production aircraft could differ from each other by as much as several hundred kilograms.〔〔〔Gunston 1995, p.386.〕 In 1933, a single TB-3-4M-17F was streamlined with removal of turrets and bomb shackles, covering of all openings, and fitting of wheel spats. This resulted in only a 4.5% increase in top speed and a similar increase in the range. Tupolev concluded that streamlining was minimally beneficial for large and slow aircraft. To study the effect of corrugated skin, in January–February 1935 a single TB-3-4AM-34R had the corrugations incrementally covered with fabric. This resulted in a 5.5% gain in top speed and a 27.5% increase in the ceiling. The same aircraft demonstrated a significant increase in climb rate when fitted with experimental four-blade propellers.〔〔Vanags-Baginskis 1988, p.12.〕 ;Record flights〔〔Duffy and Kandalov 1996, p.211.〕 * TB-3-4M-34R set a flight endurance record of 18 hours and 30 minutes. * TB-3-4AM-34FRN with A. B. Yumashev at the controls set a number of payload-to-altitude records: * * 11 September 1936 – to , improved to on 28 October. * * 16 September 1936 – to * * 20 September 1936 – to 抄文引用元・出典: フリー百科事典『 ウィキペディア（Wikipedia）』 ■ウィキペディアで「Tupolev TB-3」の詳細全文を読む スポンサード リンク
|